Filter
Top Products
Using the AX-Synth as MIDI controller
30
The AX-Synth’s FAVORITE [WRITE] button flashes to
indicate that SysEx data are being received. When all
data blocks have been received, the display changes
to “Urt” (writing data) and the FAVORITE [WRITE]
button lights.
(5) Wait until “dne” appears in the AX-Synth’s display
and until the FAVORITE [WRITE] button starts flash-
ing.
Note: If the “Err” message appears during the reception of
bulk data, the AX-Synth was unable to process the data
correctly, then stop the sequencer. The FAVORITE [WRITE]
button will go dark at that time. In such a case, please
repeat the entire procedure.
(6) Switch the AX-Synth off, wait a moment, then
switch it back on again.
Note: We recommend using the librarian software
included in the “AX-Synth Editor” to transmit and receive
the AX-Synth’s settings to your computer. This software is
available for the Mac and PC platforms and can be down-
loaded from Roland’s website: www.Roland.com.
AX-Synth_e2 Page 30 Monday, October 12, 2009 3:41 PM