Filter
Top Products
8
Assembling the DP-970
Make sure that another person is on hand to help with the assembly and setup.
To move the piano, lift it carefully—all the while keeping it level. Be very careful, when you
assemble and move the piano, to make sure that you do not drop it on your hands or feet.
Should you remove screws, cord clamps, or stabilizer, make sure to put them in a safe place out
of children’s reach, so there is no chance of them being swallowed accidentally.
■
Check the Parts
Before you begin assembling the DP-970, check that all the
parts were supplied.
You will also need to have a Phillips screwdriver.
fig.st900parts.e
1:Attachment screw (M6 x 20mm) x 8
2:Stabilizer screw (M4 x 16mm) x 6
3:Cord clamp x 4
The speaker box can also be installed so that it faces toward the
rear instead of toward the front. Having the speaker box face out
the rear of the instrument allows the speakers to be directed
toward listeners when the back of the instrument faces the
audience.
fig.stsp.e
■
Assembly Procedure
• At first, assemble the entire unit in a temporary fashion,
without really tightening the screws. Then, after checking
the overall alignment of the boards (and gently shifting
certain parts where necessary), go around and tightly fasten
each of the screws.
• Be careful when assembling the DP-970, so as to avoid
scratching the side boards.
When securing the screws, lay the entire unit sideways
with the rear side of the DP-970 at the bottom.
1.
Secure the left side board to the speaker box with
the attachment screws (in two places).
Attach so that the speaker cord at the rear of the speaker
box is directed to the right.
2.
Secure the right side board to the speaker box with
the attachment screws (in two places).
fig.st1.e
3.
Set the stabilizer in the holes in the side boards (in
six places).
fig.st3.e
Take care not to attach the left and right stabilizer to the
wrong sides.
fig.st900SAP
4.
Raise the entire assembly.
When standing the assembled unit up, grasp near the
speaker box, and gently raise the assembly.
fig.st4
3
2
1
Speaker box
Stabilizer
(left)
Stabilizer (right)
Side board (right)
Side board
(left)
DP-970
Pedal Board
Normal direction When facing to the rear
RearFront RearFront
Speaker
box
Speaker
box
1
2
Speaker box
Side board left
Attachment screw
Side board right
Stabilizer
screws
DP-970_e.book 8 ページ ２００６年３月３１日 金曜日 午後２時２７分