Filter
Top Products
Panel Descriptions
7
Deutsch Français Italiano Español Português NederlandsEnglish
EFX LOOP A, B Jacks
These are for connecting external eects units.
There are two systems, A and B (monaural).
Connect the external eects unit INPUT to the SEND jack, and the OUTPUT to the RETURN jack.
[LOOP] switch
When PARALLEL is set, the external eects sound and the direct sound are mixed.
When SERIES is set, only the external eects sound is played.
* When SERIES is set, if the volume of the external eects unit is turned down completely, or the power is not turned on, no sound will be heard.
[LEVEL] switch
Use this switch to change the input/output level of an eects loop. According to the input/output level of the connected equipment, select +4 dBu or
-10 dBu. When the input/output level of the connected equipment is high, set +4 dBu, and when it is low, set -10 dBu.
* Depending on the power supply you are using, the two cables connected to SEND and RETURN may pick up more noise if they are placed
apart from each other.Bundle the cables together.
* To prevent malfunction and equipment failure, always turn down the volume, and turn o all the units before making any connections.
* When connection cables with resistors are used, the volume level of equipment connected to the inputs (INPUT, MAIN IN, and RETURN jacks) may be low. If this happens, use
connection cables that do not contain resistors.
External eects unit
OUTPUTINPUT
*1 Important Notes on FOOT CONTROL/LINK IN and LINK OUT Jacks
• Do not connect any device other than GA-212/GA-112 for link connection
or exclusive GA FOOT CONTROLLER (GA-FC) to the FOOT CONTROL/LINK IN
jack.
• Do not connect any device other than GA-212/GA-112 for link connection to
the LINK OUT jack.
• This instrument is equipped with balanced (TRS) type jacks. Wiring diagrams
for these jacks are shown below.
TIP
RING
SLEEVE (GND)