Filter
Top Products
16
Chapter 2. Performance
Applying Effects to the Sound
fig.panel2-5
■
Adding Reverberation to the Sound (Reverb)
By applying the reverb effect you can produce a pleasant reverberation, making it
sound as though you were performing in a concert hall.
1
Press the [REVERB] button.
The button’s indicator will light, and a reverb effect will be applied to the sound.
To cancel the reverb effect, press the [REVERB] button, getting its indicator to go dark.
■
Changing the depth of the reverb effect
The amount (depth) of the reverb effects can be set to any of eight levels.
2
Hold down the [REVERB] button and press the [-] or [+] button.
The currently specified value will be displayed.
Higher values will produce a deeper effect.
■
Adding richness to the sound (Chorus)
By adding the chorus effect, you can give the sound greater dimension, with more
fatness and breadth.
1
Press the [CHORUS] button.
The button’s indicator will light, and a chorus effect will be applied to the sound.
To cancel the chorus effect, press the [CHORUS] button, getting its indicator to go dark.
■
Changing the depth of the chorus effect
The amount (depth) of the chorus effects can be set to any of eight levels.
2
Hold down the [CHORUS] button and press the [-] or [+] button.
The currently specified value will be displayed.
Higher values will produce a deeper effect.
21
When you play back an
internal song, the reverb effect
will automatically be turned on
(the button’s indicator lights).
When the power is turned on,
reverb is set to “4.”
When you hold down the
[REVERB] button, the currently
specified reverb depth value
will be displayed.
NOTE
You cannot save separate
reverb settings to each tone
individually.
You can save separate chorus
effect on/off settings to each
tone individually. The original
settings are restored when the
power is turned off.
When the power is turned on,
chorus is set to “4.”
MP-70_e.book 16 ページ ２００６年３月２９日 水曜日 午後４時１７分