Roland RS-50 Musical Instrument User Manual


 
106
Parameter list
Patch parameters
Patches
Patch Common parameters (p. 45)
Patch Tone parameters (p. 46)
Patch Effects parameters
* The same parameters are also provided for Rhythm sets.
Parameters
Value
Name
Patch Name space, A–Z, a–z, 0–9, ! “ # $ % & ‘ ( ) * + , - . / : ; < = > ? @ [ ¥ ] ^ _
` { | }
Category * Refer to
“Selecting a patch by category”
(p. 20).
Key Mode SINGLE, SPLIT, DUAL
Patch Level 0–127
Tone Balance -64 (LOWER) – +63 (UPPER)
Split Point A0–C8
Split Arp Split Arpeggio UPPER, LOWER, BOTH
Solo Switch OFF, ON, UPPER, LOWER
ModulationDst Modulation Destination UPPER, LOWER, BOTH
PitchBend Dst Pitch Bend Destination UPPER, LOWER, BOTH
Modify Dest Modify Destination UPPER, LOWER, BOTH
* This is linked with the panel’s [DESTINATION TONE] setting.
ExpressionDst Expression Destination UPPER, LOWER, BOTH
Active Exp Sw Active Expression Switch OFF, ON
Parameters
Value
No. Original Tone Number 0001–0640
Tone Pan L64–63R
MFX Switch Multi-Effects Switch BYPASS, ON
Chorus Send Lvl Chorus Send Level 0–127
Reverb Send Lvl Reverb Send Level 0–127
Coarse Tune -48– +48
Fine Tune -50– +50
Portamento Sw Portamento Switch OFF, ON
Portamento Time 0–127
Velo Sens Depth Velocity Sensitivity Depth -64– +63
Velo Sens Ofs Velocity Sensitivity Offset -64– +63
Pitch Bend Range 0–24
Filter LFO Filter LFO Switch OFF(PCH), ON(FLT)
LFO Rate -64– +63
LFO Depth -64– +63
LFO Delay -64– +63
Cutoff Freq Cutoff Frequency -64– +63
Resonance -64– +63
Attack Time -64– +63
Decay Time -64– +63
Release Time -64– +63
Parameters Value
Multi-effects group
Type
Multi-effects Type 00 THROUGH–47 FBK RIPPER
--- Multi-effects Parameters The number of parameters varies depending on the Multi-effects
Type. Refer to
“Setting multi-effects parameters”
(p. 68).
Send Lvl to Cho Multi-effect send level to chorus 0–127
Send Lvl to Rev Multi-effect send level to reverb 0–127
Ctrl 1 Multi-effects Control 1 Refer to
“Setting multi-effects parameters”
(p. 68).
Ctrl 2 Multi-effects Control 2 Refer to
“Setting multi-effects parameters”
(p. 68).
Chorus effects group
Type
Chorus type CHORUS1, CHORUS2, CHORUS3, CHORUS4, FEEDBACK
CHORUS, FLANGER, SHORT DELAY, SHORT DELAY(FB)
Pre-LPF Chorus pre-low pass filter 0–7
Level Chorus Level 0–127
RS-50_e3.book 106 ページ 2003年11月7日 金曜日 午後7時1分