Filter
Top Products
41
Overview Basic Operation Adv. 1 (Kit) Adv. 2 (Phrase) Adv. 3 (Other) Appendix
Using the Knobs to Control the FX (FX CONTROL)
You can use [Knob 1]–[Knob 3] to control FX parameters. For each FX, the most suitable parameters are automatically assigned
to the three knobs.
Changes you make in the FX CONTROL screen are not saved to the kit.
1. Press the [FX CTRL] button.
The FX CONTROL screen appears.
MEMO
You can also access the FX CONTROL screen from the KIT screen by pressing [Button 3] (FX CTRL).
[Button 1] (SEND)
moves to a screen
where you can set
the send level for
each pad.
FX type
Pads for which FX is enabled.
[Knob 1–3] adjusts the eect parameters.
[Button 3] (BYPASS) temporarily turns FX o.
MEMO
When you’re recording a phrase loop (REC mode), knob movements are recorded on the phrase’s FX track. [Button 1]
operates as TR MUTE; the FX track will be muted when you turn it on.
Adjusting the FX send level for each pad (FX CONTROL-FX SEND)
The FX SEND (FX send level) screen is also accessible from the FX CONTROL screen.
1. Press the [FX CTRL] button.
2. Then press [Button 1] (SEND) to enter the FX SEND (FX send level) screen.
Operations are as mentioned above p. 40.
Remember that any changes made via this page will NOT be saved to the kit. Movements or adjustments to send levels while in
Rec mode of the phrase loop will NOT be recorded into the phrase.