Filter
Top Products
112
Troubleshooting
Are you playing a new User song?
➝
Play back a song that contains performance data.
New User songs are indicated by “ ” in the display.
Is the volume level of the backing part and
percussion part set to “0?”
(SETUP/UTILITY/PercPartLevel, BackingLevel; p.
76, p. 77)
➝
Press [+] or [-] to make the setting.
Press [SHIFT] + [SONG] to jump to the backing part
volume settings screen.
Specific Part in Song Not Being
Played
Does [PART MUTE] light? (p. 84)
➝
Press [PART MUTE] so that the light is turned off.
Is the volume level for each part set to “0?”
(SONG/PART/Level; p. 88)
➝
Press [+] or [-] to make the setting.
TD-6V Not Playing Even During
Performance of External Sequencer
or Keyboard
Is the part’s MIDI channel correct? Or is the
channel set to “OFF?” (SETUP/MIDI PART/Part
CH; p. 102)
➝
Press [+] or [-] to make the setting.
Is the volume level for each part set to “0?”
(SONG/PART/Level; p. 88)
➝
Press [+] or [-] to make the setting.
External Sequencer Not Playing
Even During Performance of TD-6V
and Pads
Is the part’s MIDI channel correct? Or is the
channel set to “OFF?”
(SETUP/MIDI PART/Part CH; p. 102)
➝
Press [+] or [-] to make the setting.
In GM mode, No Sound of a
Specific Part in a Performance
Is it set not to receive MIDI messages?
(SETUP/GM PART/Part Rx Sw; p. 102)
➝
Press [+] or [-] to make the setting.
No Sound/Low volume from
Device Connected to the MIX
IN Jack
Could you be using a connection cable that
contains a resistor?
➝
Use a connection cable that does not contain a resistor.
Is the volume level of the connected device
turned down completely?
➝
Refer to the owner’s manual for the device, then set the
volume.
TD-6KV_e.book 112 ページ ２００５年１月２４日 月曜日 午後７時４分