Filter
Top Products
11
If the Clutch Was Apart from the Hi-Hat
If the hi-hat clutch is inadvertently removed from the hi-hat,
use the following procedure to reassemble and attach the
clutch.
Due to the different shape, the clutch included with the
hi-hat stand cannot be used with the VH-11. Be sure to
use the special VH-11 clutch.
fig.HH-Assy1.e
* Orient the stopper (upper) so that it matches the groove in the
hi-hat.
fig.HH-Assy2.e
fig.HH-Assy3.e
Clutch Top
VH Offset Adjustment Screw
Plastic Washer
Rubber Washer
Stopper (Upper)
Spring
Stopper (Lower)
Set the screw to front.
See the direction
as it is.
Assemble these
two parts fit in
this direction
completely.
Player Side
Hi-Hat Being Properly Assembled
Player Side
The screw being
in this direction
The VH offset
adjustment screw
being fully tightened
The upper end of the
screw pipe of the
stopper can be seen
3–4 mm
VH-11_e 11 ページ ２００５年４月１２日 火曜日 午後１時２０分