Filter
Top Products
8
Adjusting the Other Sound Module and
VH-11’s Offset
* If “VH11” is available as a Trigger Type setting on the TD-20
you are using, follow the instructions in
Using the TD-12
(p.
6) to set the TD-20 and adjust the VH-11’s offset.
1.
Confirm that the VH-11 and TD-20 are
connected properly.
2.
After making the hi-hat settings, release your
foot from the pedal, and while keeping your foot
off the pedal, turn on the power to the TD-20.
* The offset cannot be adjusted correctly if the hi-hat is making
contact with the motion sensor unit when the power is turned on.
3.
Loosen the clutch screw and let the hi-hat rest
naturally on the motion sensor unit.
4.
Press the TD-20’s [TRIGGER] button.
5.
Press the [F1 (BANK)], [F2 (BASIC)], and
[F3 (HI-HAT)] buttons, and make the TD-20’s
settings.
For details, refer to the TD-20 owner’s manual.
6.
Adjust the offset by rotating the VH-11’s VH
offset adjustment screw. See the column below.
fig.Offset.e
1.
Confirm that the VH-11 and the sound module
are connected properly.
2.
After making the hi-hat settings, release your
foot from the pedal, and while keeping your foot
off the pedal, turn on the power to the sound
module.
* The offset cannot be adjusted correctly if the hi-hat is making
contact with the motion sensor unit when the power is turned on.
3.
Loosen the clutch screw and let the hi-hat rest
naturally on the motion sensor unit.
4.
Make the sound module’s settings.
For details, refer to the owner’s manual supplied with the
sound module.
5.
Adjust the offset by rotating the VH-11’s VH
offset adjustment screw. See the column below.
Notes to Observe When Using the
TD-10+TDW-1, TD-8, and TD-6V/6
Do not turn on the power to the sound module with the hi-hat
in the closed position; this may cause faulty operation. Make
sure the hi-hat is open when turning on the power.
Using the TD-20
Button
Parameter Value
[F1 (BANK)]
Trigger Type VH12
[F2 (BASIC)]
Sensitivity 10
Threshold 6
[F3 (HI-HAT)]
Hi-Hat Ctrl Type FD
CC Max 90
CC Resolution NORMAL
VH Offset
Adjustment
Screw
OPEN CLOSE
Using the TD-10+TDW-1/
TD-8/TD-6V/TD-6
Parameter
Value
TD-10 + TDW-1
TD-8 TD-6V/6
Trigger Type
HH CY1/PD7 CY Type
Sensitivity 6 10 10
Threshold 6 4 4
Curve Linear LINEAR LINEAR
Scan Time 2.0 2.5 2.5
Retrigger Cancel 4 8 8
Mask Time 8 8 8
Xtalk Cancel 20 20 20
Mount Type CymMount – –
How to Adjust the VH Offset
• Adjust until you are satisfied with the correspondence
between the hi-hat’s opening and closing action and
the change in tone.
• If the closed hi-hat sound is difficult to attain, rotate
the VH offset adjustment screw towards “CLOSE.”
If the open hi-hat sound is difficult to attain, rotate the
screw towards “OPEN.”
If the sound cuts off when you strike the hi-hat
forcefully, rotate the VH offset adjustment screw
towards “OPEN.”
VH-11_e 8ページ ２００５年４月１２日 火曜日 午後１時２０分