Filter
Top Products
23
Installing the ARX Expansion Board
4.
Insert the board into the VS-700R’s non-latched board holders until you hear a click.
fig.attach02.eps
5.
Gently lower the board into place.
fig.attach04.eps
6.
From above, press down on the board at the three locations indicated in the illustration until the
latched board holders lock into place.
fig.attach06.eps
7.
Verify that the latched board holders are locked.
fig.attach07.eps
8.
Use the screws that you removed in step 2 to fasten the cover back in place.
Align board’s
holes with holders
Connector
of board
Connector
of the VS-700R
Board
Non-latched holders
Edge of the board
where the logo
is affixed
Near the cutouts
in the board
VS-700R_e1.book 23 ページ ２０１０年６月１５日 火曜日 午後４時５９分