Filter
Top Products
15
LEFT/RIGHT MIX
In a live sound application the LEFT/ RIGHT MIX outputs are connected to a power amplifier or powered speak-
ers. In a recording application, the LEFT/ RIGHT MIX outputs are used to connect a stereo device such as com-
puter sound card, DAT, or cassette recorder.
3/4 OUTPUT
In a live sound application, the 3/4 bus outputs are connected to a power amplifier or powered speakers. In a
recording application, the 3/4 outputs are used to connect a stereo device such as computer sound card, DAT,
or cassette recorder.
FX RET 1 LEFT/RIGHT
The FX RET 1 LEFT/RIGHT are stereo inputs that are generally used to connect the outputs of an effects
processor, but can also accept the signal from any line level source like a keyboard, recorder and even another
mixer. The signal connected to the FX RET 1 LEFT/RIGHT will feed the main LEFT/RIGHT MIX bus. The over-
all level is controlled by the FX RETURN 1 knob located in the master section on the front panel
FX RET 2 LEFT/RIGHT
The FX RET 2 LEFT/RIGHT are stereo inputs that are generally used to connect the outputs of an effects
processor, but can also accept the signal from any line level source like a keyboard, recorder and even another
mixer. The signal connected to the FX RET 2 LEFT/RIGHT will feed the main LEFT/RIGHT MIX bus. The over-
all level is controlled by the FX RETURN 2 knob located in the master section on the front panel
AUX 1 Output
The signal present at the AUX 1 output is sent from the AUX 1 bus, which is fed from the AUX 1 send on the
input channels. The AUX 1 output can be used as the MONITOR MIX bus in a live sound situation by connecting
the output to a power amp and monitor speaker.
AUX 2 OUTPUT
The AUX 2 output is used to send a signal to an external signal processor such as a delay or reverb. The signal
present at the AUX 2 output is sent from the AUX2/DSP bus, which is fed from the AUX2/DSP send on the input
channels.
CONTROL ROOM LEFT/RIGHT
The Control Room outputs are used to connect a studio monitor system. The Control Room outputs have the
same output as the L/R MIX, however, the level can be adjusted independently from the main mix using the C
ROOM/HEADPHONES control.
MONO OUTPUT
The Left and Right Mix outputs are summed together and sent to the MONO output. The level of the Mono sig-
nal can be adjusted using the MONO OUT level control located just below the connector and used to feed a
speaker zone in a fixed installation.
AC INLET
Connected the supplied Samson AC adapter here. Before connecting
the supply, make sure that the MDR10 POWER and PHANTOM
POWER switches are in the off position.
MDR10 Input and Output Connections
EXTERNAL OUTPUT JACKS
The MDR10 features several output connectors allowing you to interface a variety of external devices. A stereo
recording device such as a cassette recorder can be connected to the 2 Track jacks, and power amplifiers can
be connected to the CONTROL ROOM and MAIN output jacks.
5
6
7
8
9
10
11
12
13
POWER PHANTOM
POWER INPUT
ON ON
MADE IN CHINA
www.samsontech.com
oo
l
l
13