Filter
Top Products
Owner's Manual
15
XML POWERED MIXERS
Speaker Outputs - XML610 & XML910
The XML610 and XML910 powered mixers contain two mono power ampliers and, depending on the operating mode,
the two ampliers can be used independently for LEFT and RIGHT MAIN outputs or for MONO MAIN + MONITOR outputs.
NOTE: Use the Power Amp MODE switch to select which signal is sent to the speaker output jacks.
The total impedance load for each amplier must not exceed 4 Ohms, therefore, if you want to only connect a single
speaker to each amp output, use a 4–8 Ohm speaker.
You can connect up to four speakers at one time. One speaker with an impedance of 8 Ohms can be connected to each
of the amp’s Speakon and 1/4” jacks. The Speakon and 1/4” jacks are wired in parallel, so the total impedance when two 8
Ohm speakers are connected is 4 Ohms.
42. AMP 1 Speaker Outputs - The AMP 1 output has one Speakon and one 1/4” phone connector wired in parallel. These
powered outputs can be used to connect your left side main PA speaker when using the XML610 or XML910 in MAIN/
MAIN mode. When operating in MAIN/MONITOR mode, the AMP 1 powered output connectors are used to connect
left and right side MAIN PA speakers.
43. AMP 2 Speaker Outputs - The AMP 2 output has one Speakon and one 1/4” phone connector wired in parallel. These
powered outputs can be used to connect your left side main PA speaker when using the XML610 or XML910 in MAIN/
MAIN mode. When operating in MAIN/MONITOR mode, the AMP 2 powered output connectors are used to connect
to oor or side ll monitors facing the performers.
43 42