Filter
Top Products
Owner's Manual
21
XML POWERED MIXERS
Using the Internal Digital Eects
The XML series of mixers features built-in, high quality, 24-Bit Digital Signal Processors (DSP), oering studio grade eects.
The DSP features clean Delay, lush Reverb and multi-eects like Chorus + Delay or Chorus + Reverb. You can also add a
broad range of studio quality eects by simply dialing through the 100 presets. The following details the operation of the
internal DSP eects:
1. Connect a mic or instrument to the desired channel and adjust the volume and equalizer
to your liking.
2. Select the desired preset using the EFFECTS SELECT switch. Set the DSP SELECT switch
to one of the following 100 eects:
0–9 Performance
10–19 Hall Reverb
20–29 Plate Reverb
30–39 Spring Reverb
40–49 Echo
50–59 Flange + Verb
60–69 Chorus + Verb
70–79 Echo + Verb
80–89 Chorus
90–99 Flange
3. Once you have selected the desired eect preset, raise the AUX 2 EFX control on the
channels you wish to apply the digital eect to.
4. Use the EFX to MAIN/MON knob in the MAIN/MONITOR section to adjust the EFFECTS
Return level. The EFX to MAIN/MON control is the overall level control for the DSP eects
processor. If you are not using the mixer in MAIN/MONITOR or BRIDGE mode, be
sure to raise the EFX to MAIN/MON control on both the MAIN and MAIN/MONI-
TOR sections so the level of eect is the same in both speakers.
NOTE: If the eect sound is distorted even though the EFX to MAIN/MON is turned
down, lower the AUX 2/EFX controls of each channel until you no longer hear distortion.