Filter
Top Products
14
EFX RETURN - Left and Right Auxiliary Input
These two 1/4-inch phone jacks are used to connect the outputs of stereo devices such as external effects
processors.
AUX 2 SEND - Effects Output
The AUX 2 SEND output is used to interface an external signal processor like a delay or reverb. The signal
present at the AUX 2 SEND output is sent from the EFFECTS bus, which is fed from the AUX 2/ EFX send
on the input channels and the EFX LEVEL send in the Effects section.
EFX FOOTSWITCH - Footswitch Jack
With a footswitch connected to this jack, you can turn on and off the on-board digital effects by simply step-
ping on the footswitch.
AMP IN - Power Amplifier Left and Right Inputs
The Left and Right AMP IN 1/4-inch phone jacks are used to make a direct connection to the XM910’s
internal power amplifiers. You can connect a stereo source like the output from an external mixer here. In
addition, the Left and Right AMP IN jacks can be used combination with the MAIN Left and Right Output
jacks to create an effects loop when connecting an external signal processor to effect the entire system.
For more information on using the AMP IN connectors as an effects loop, see the section, on page 19 of
this manual.
MIX OUT - Line Level Left and Right Main Outputs
The signal present at this connector is the MAIN bus signal, which has passed through the MAIN/ MASTER
level control and the graphic equalizer. The nominal output level is +4dBu and the impedance is100 Ohms.
In addition, the Left and Right AMP IN jacks can be used combination with the MAIN Left and Right Output
jacks to create an effects loop when connecting an external signal processor to effect the entire system.
For more information on using the AMP IN connectors as an effects loop, see the section, on page 19 of
this manual.
AUX 1 SEND - Monitor Output
The MONITOR bus signal is present at this connector. The signal is passed through the MONITOR /MAS-
TER level control and graphic equalizer before it reaches the AUX 1 SEND connector. The nominal output
level is +4dBu and the impedance is100 Ohms.
CD 1 IN - Line Level CD/TAPE Input
Used to connect a stereo output device such as cassette recorder or CD player.
CD 2 IN - Line Level CD/TAPE Input
Used to connect a stereo output device such as cassette recorder or CD player.
REC OUT - Record Output
The signal present at this connector is the MAIN bus signal before it has passed through the MASTER level
control and graphic equalizer. The nominal output level is -10dBV and the impedance is100 Ohms.
XM910 Input and Output Connections
7
8
9
MASTER SECTION INPUT AND OUTPUT CONNECTORS
The XM910 features several output connectors allowing you to interface a variety of external devices. A stereo
recording device such as a cassette recorder can be connected to the REC OUT jacks, and additional power
amplifiers can be connected to the MONITOR and MAIN output jacks.
5
6
12
13
10
11