Filter
Top Products
10
Putting the diversity receiver into operation
Mounting the diversity receiver to a camera
Use the supplied CA 2 camera adapter to mount the receiver to a camera’s
flash mount.
̈ Determine where on the perforated plate ƹ the flash mount
adapter ƺ will need to be fastened so that the receiver can best be
attached to the camera.
̈ At this position, place a square nut ƻ under the perforated plate ƹ.
̈ Fasten the flash mount adapter ƺ to the perforated plate ƹ using the
square nut ƻ.
̈ Lift one side of the belt clip Ƽ as shown.
̈ Press down the belt clip Ƽ at one fixing point and pull it out of the
receiver housing.
̈ Repeat for the other side.
ƺ
ƻ
Ƽ
ƽ