Filter
Top Products
35
Accessories
If a problem occurs that is not listed in the above table or if the problem
cannot be solved with the proposed solutions, please contact your local
Sennheiser partner for assistance.
To find a Sennheiser partner in your country, search at
www.sennheiser.com under “Service & Support”.
Accessories
The following EK 2000 accessories are available from your specialist
dealer:
009950 BA 2015 accupack
009828 L 2015 charger
009827 DC 2 power adapter for external DC powering (12 V)
009986 CA 2 camera adapter
005022 CL 1 line cable (jack to jack, balanced)
087047 CL 500 line cable (XLR-3 to jack, balanced)
Audio signal is
distorted
Transmitter sensitivity
is adjusted too high
Adjust the transmitter
sensitivity correctly
(see the instruction manual
of the transmitter).
Receiver’s audio output
level is adjusted too
high
Reduce the audio output level
(“AF Out”, see page 24).
No access
toacertain
channel
During scanning,
an RF signal has been
detected on this
channel and the
channel has been locked
Set the transmitter operating
on this channel to a different
channel and redo the
frequency preset scan
(see page 22).
During scanning, a
transmitter of your
system operating on
this channel has not
been switched off
Switch the transmitter off and
redo the frequency preset scan
(see page 22).
Problem Possible cause Possible solution