Filter
Top Products
59
Inserting and changing the battery
Ǡ Slide the cover of the battery compartment ¿ in the direction of the
embossed arrow until it clicks audibly.
Ǡ Open the cover.
Ǡ Insert the 9 V PP3 battery (IEC 6 LR 61). Please observe correct polarity
when inserting the battery.
Ǡ Close the battery compartment.
Ǡ To remove the battery, push the small red lever ƹ in the battery
compartment towards the bottom side of the receiver.
Note:
We recommend powering the receiver by a standard PP3 alkaline
battery. If powered by a rechargeable 9 V battery, the operating time
will be drastically reduced.
Connecting the antenna
Ǡ Screw the antenna ³ onto the antenna socket (M3 connection).
Connecting sound recording and reproducing equipment
Sound recording and reproducing equipment such as amplifiers, video
cameras, tape recorders etc. can be connected to the EK 500 receiver.
Ǡ Use the supplied line cable with 3.5 mm jack plug to connect the
sound recording or reproducing device to the line output (AF OUT)
¶.
Ǡ Lock the jack plug by screwing down the locking ring.
Connecting the headphones
Ǡ Connect the headphones to the headphone output (EARPHONES)
² via a 3.5 mm jack plug.
Adjusting the volume / AF output level
Use volume control º to adjust the volume / AF signal level for sockets ²
and ¶.