Filter
Top Products
37
36
16 Selection of possible transmission frequencies
Your SKM 3072-U hand-held transmitter can be operated on one of up
to 32 different frequencies. These frequencies and their sequence are pre-
programmed by the factory and must only be changed by your Sennheiser
distributor who has the required specialist equipment.
̈ Press the SET button to get into the setting mode. If you press SET
again, the display indicates the transmission frequency in
alternation with the channel number.
̈ With the ̃/̅ buttons you can now change the transmission
frequency.
̈ If the transmission frequencies have been assigned channel
numbers, the channel numbers are indicated in alternation with
the transmission frequencies. If no channel numbers are assigned,
“CH---” appears on the display. => Entering and assigning a
channel number (u chapter 17)
̈ Press the SET button for more than a second to store your setting.
“Sto” briefly appears on the display, indicating that the new setting
has been stored. The display then switches back to the standard
display.
Note:
Only after your setting has been stored – i.e after you have pressed
the SET button for more than a second – does the PLL switch to
the new transmission frequency, the display then ceases to flash.
You can discontinue your preselection by briefly (!) pressing the
SET button.
If you do not press any of the three programming buttons for
more than 14 seconds, the transmitter returns to the frequency to
which it was last set and the display switches back to the standard
display.
17 Entering and assigning a channel number
You can assign channel numbers to the pre-programmed frequencies (u
chapter 16). These channel numbers (from 001 to 255) can be entered
directly on the SKM 3072-U hand-held transmitter.
̈ Press the SET button to get into the setting mode.
̈ If you press SET twice, either “CH---” or the channel number
which has been assigned to the currently selected transmission
frequency begins to flash on the display.
̈ With the ̃/̅ buttons you can now select the desired channel
number. Holding down a button initiates fast search, continually
cycling from the beginning.
̈ Press the SET button for more than a second to store your setting.
“Set” briefly appears on the display, indicating that the new setting
has been stored. The display then switches back to the standard
display.
Note:
If you do not press any of the three programming buttons for
more than 14 seconds, the transmitter returns to the frequency to
which it was last set and the display switches back to the standard
display. The channel number which was last selected is also kept.