Filter
Top Products
9(GB)
Channel selection mode Freqency selection mode
+ button – button
+ button – button
Display example for CE62 model
2 Press the + or – button to select the channel number (or
frequency).
Pressing the + button cycles the indication in the order
shown in separate “Sony Wireless Microphone System
Frequency List.” Pressing the – button cycles the
indications in the opposite direction.
Hold down the button to change the channel number (or
frequency) quickly.
3 When the desired channel number (or frequency)
appears, turn the POWER switch to OFF to release
Setting mode, or press the SET button to continue
operations in Setting mode.
The next time you turn on the microphone (by turning the
POWER switch to ON), the microphone will enter Transmit
mode with the selected channel number (or frequency).
Notes
• The microphone cannot transmit in Setting mode.
• Make sure that the channel selected on the microphone is
the same as that selected on the tuner being used in the
same system.
• Depending on the noise or interference conditions, all
selectable channels may not be usable. If necessary, you
can determine which channels are usable by cycling the
channel selection through a number of channels on the
tuner with the microphone set to OFF. Those channels for
which the RF indicator on the tuner does not light are
usable.
• The microphone may not operate correctly if it is turned
on immediately after being turned off in Setting mode.
Wait for a few seconds before turning the power on again.