Filter
Top Products
21
1 POWER INDICATOR
This LED lights to show when power is connected to the console.
2 PHANTOM POWER
Many professional condenser mics need PHANTOM POWER, which is a method of sending a powering
voltage down the same wires as the mic signal. Press the switch to enable the +48V power to all of the MIC
inputs. The adjacent LED illuminates when the power is active.
WARNING: TAKE CARE when using unbalanced mics which may be damaged by the phantom
power voltage. Balanced dynamic mics can normally be used with phantom power switched on
(contact your microphone manufacturer for guidance).
Mics should always be plugged in, and all output faders set to minimum before switching the
Phantom Power ON to avoid damage to external equipment.
2-TRACK
3 2-TRACK IN
These two RCA phono sockets are unbalanced Left and Right line-level inputs, used for connecting a play-
back device.
4 2-TRACK LEVEL CONTROL
This adjusts the signal level from the 2-Track inputs.
5 2-TRACK TO MIX
Press this switch to route the 2 Track input signals to the MIX Left/Right signals at the MIX outputs.
MONITOR SOURCE
The following three switches select the signal source(s) to be monitored. More than one can be selected at
a time.
6 MIX
Press this switch to monitor the main mix outputs.
7 SUB
Press this switch to monitor the sub-group (L & R) outputs.
8 2-TRACK
Press this switch to monitor the 2-Track input signal.
MONITOR OUT
9 MONITOR OUTPUT LEVEL
This control sets the signal level fed to the MONITOR LEFT & RIGHT outputs.
10 MONITOR OUTPUTS
The Monitor Outputs are on 3-pole 6.35mm (1/4") jacks and are balanced.
11 HEADPHONES LEVEL
This control sets the level of the Headphone output.