Filter
Top Products
Page 16
l Listen carefully for the characteristic sound of `feedback. If you cannot achieve satis-
factory input level setting without feedback, check microphone and speaker place-
ment and repeat the exercise.
Note: The initial settings should only be regarded as a starting point for your mix. It is
important to remember that many factors affect the sound during a live performance,
for instance the size of the audience!
You are now ready to start building the mix and this should be done progressively,
listening carefully for each component in the mix and watching the meters for any hint of
overload. If this occurs, back off the appropriate Channel Fader slightly until the level is
out of the red segments, or adjust the Master Fader.
Note:
The level of any source signal in the final output is affected by many factors, principal-
ly the Input Sensitivity control, Channel Fader and Output Faders. You should try to use
only as much microphone gain as required to achieve a good balance between signals,
with the faders set as described above. If the input gain is set too high, the channel fader
will need to be pulled down too far in compensation to leave enough travel for successful
mixing and there is a greater risk of feedback because small fader movements will have a
very significant effect on output level. If the gain is set too low, you will not find enough
gain on the faders to bring the signal up to an adequate level.
USERMAN.QXD 13/06/97 12:27 Page 16