SoundCraft Spirit Live 3-2 Music Mixer User Manual


 
Page 26
6. Using the M3 screw, washer and nut provided, secure one end of the
earth lead supplied to the screw hole on the left hand side of the
Expander front panel, underneath the arm rest as shown. Ensure that
any paint overspray is removed from the inside of the panel to provide a
good electrical contact with the panel.
7. Using the M5 screws, washers and nuts supplied, bolt the Expander
chassis to the Console chassis as shown.
N.B. Ensure correct orientation and alignment.
8. Re-assemble the Expander top panel and base, gently sliding the units
together as the panel is lowered and threading the Expander bus loom
and earthing lead through the aperture into the console base.
9. The Expander earthing lead must now be joined to the existing earthing
point on the power connector on the main console top panel, which
should be placed knobs down with the rear of the panel next to the rear
of the chassis. Remove the securing nut and washer and reassemble
with the expander earthing lead connected in contact with the existing
earthing lead as shown opposite. Ensure that the nut is tightened
securely.
10. Rotate the main console top panel backwards and reassemble to the
base, taking care not to strain the earthing lead and connecting the bus
loom from the Expander onto the track-side pins of the bus connector
on the Console Master PCB as shown. Carefully adjust the position of
the bus loom as the panel is lowered to ensure that the slack in the
cable folds on the right-hand side of the Master PCB and does not
become trapped between the boards and the base panel.
11. To ensure good mechanical fit, some realignment can be carried out as
the top and base panel screws are tightened.
N.B. Taking care with paintwork, use the correct tools, keep screws safely
and the expansion of your SPIRIT LIVE 3
2
should take no longer than 15
minutes.
Earthing
Screw
Location
Motherloom
Earth Lead
(from Power Connector)
Ground lead
from power
connector
M3 Nut
and
washer
Power
Connector
Ground lead
from expander
(RV2280)
BASE
USERMAN.QXD 13/06/97 13:09 Page 26