Filter
Top Products
7
Spectralizer
Flow Chart
Quick-Start
Generator
2nd Harmonic
Encoder
Density-
Encoder
Generator
3rd Harmonic
Encoder
Effect
Original
Solo-
Taste
Kick-
Encoder
Frequency-
Encoder
Highpass-
Filter
Mix-
Encoder
Input
Encoder
Set all controls to the starting positions:
I
NPUT GAIN 0; FREQUENCY 1k; DENSITY 0; 2ND HARMONIC 0%;
3
RD HARMONIC 0%; MIX 0%.
1. Depress A
CTIVE. The status-LED illuminates.
2. Set M
IX to 50%. You will notice an increase in high
frequencies above 1kHz (starting position F
REQUENCY).
3. Set D
ENSITY to 1, to increase the audibility of the
harmonics in the next step.
4. Set 2ND HARMONIC to 50% and 3RD HARMONIC to 30%.
5. If you are using full scale material for this initial test
drive the CLIP LEDs may illuminate. Reduce the INPUT
GAIN to give additional headroom for the new harmonics.
6. To compare original and processed signal press A
CTIVE.
The status LED goes out.
Use the SOLO button to monitor the added harmonics precisely.
Diagram 1:
Signalflow Spectralizer