Filter
Top Products
D1335603_T770_880_990_MXP_User_Manual
20
1. Microphone cable
Connect the microphone to the microphone cable.
Connect the microphone cable to microphone input 1 on the system.
2. Monitor cable(s)
Scart (Europe):
Connect the Scart adapter to one of the Scart connectors on your monitor.
Scart (Europe) & RCA/S-Video (US):
Audio:
The cable with one RCA connector on one side and two RCA connectors on the other side:
Connect the two RCA connectors to your monitor (or Scart adapter) Audio Left/Right
connectors (the audio signal from the system is a monaural signal and therefore is fed
into both audio-in sockets on the monitor).
Connect the other end to ‘Audio Out’.
Video:
Connect the S-video cable to the S-video connector on your monitor (or Scart adapter).
If you do not have an S-video connector on your monitor, connect the RCA-RCA video
cable to the RCA connector on your monitor.
Connect the other end to ‘Video Out’.
3. ISDN cables
Connect the ISDN cables to the ISDN sockets (S/T-interface) provided by the service
provider. Your main number will be the number associated with the socket to which
ISDN cable number 1 is connected.
Note! Some systems and software versions do not support four ISDN lines.
North America: The system does not have a built-in network terminator. If your wall socket
provides you with an ISDN U-interface, you will need an NT1 between your system and your
ISDN line, see Appendix 9.
Note! Write down the numbers associated with each of the ISDN lines. You will need them
later to configure the system
Note! Connecting to the switched 56 network: When connecting to the switched 56 network
you may use one of the BRI interfaces on the system. Please refer to Appendix 8 for further
information.
4. Power cable
Connect the power cable from the system’s power connector to an electrical distribution
socket.