Filter
Top Products
3 Making your first recording
16
3.5 Recording the next track
Since you plugged the microphone into MIC/LINE 1 / MONO, and
didn’t plug anything into
MIC/LINE 2, the microphone signal is split
as if it was plugged into both channels.
1) Take fader 1 to the 0 mark.
2) Set the level for input channel 2 in the same way as you set it
for input channel 1 (see 3.3, “Setting the level”).
3) Set
REC FUNCTION switch for INPUT 2 to 2.
You are now ready to record on track 2.
4) Rehearse your second spoken part by playing back the first
track (adjusting the level and pan if necessary) while
speaking the words for the second track.
5) Rewind and record when you are ready.
When you are recording, the meter of INPUT 2 will show the input
levels of input 2. Since the signal is now going to track 2, the meter
for input 1 will not show anything.
6) Rewind and playback when you have recorded. Adjust the
level and pan position of the two tracks with the
LEVEL and
PAN controls for tracks 1 and 2.
Remember that the fader adjusts the level of what goes onto tape, not
the replay levels.
When you are playing back, the meter of INPUT 1 will show the level
of the signal from the left outputs, and the meter of INPUT 2 will
show the input signal level as long as the REC FUNCTION switch is
not SAFE.
7) Rewind and repeat the recording of track 2 until you are
satisfied with it.
SAFE input channel 2, and take both faders down to 0. Set
the
TRIM controls of both inputs to LINE.