Filter
Top Products
13
OPERATION
12 + 15 – Dry/Blend
The Dry/Blend function allows you to use parallel
compression. Basically, this means splitting the signal
in two and compressing only one part of the signal.
With the DRY BLEND switch, you can cycle through
three predefined levels of blend and “off”.
Choose between the following settings
:
Off: No blend
Min: 75 % wet and 25 % dry
Med: 50 % wet and 50 % dry
Max: 25 % wet and 75 % dry
The Dry Blend function is especially useful for creating
hard sustaining compression without sacrificing the
natural attack.
16 – Clipping indicators
If these LEDs flash you have a too hot signal
somewhere in the signal processing.
LED
A flashing - the input level for input A is too hot.
Recalibrate the pedal.
LED B flashing
- the input level for input B is too hot. If
you are using dual input mode (two instruments) -
recalibrate input B. If you are using Engines A+B in
serial - reduce the output level of Engine A using the
LEVEL knob.
Both LEDs flashing
- recalibrate and reduce the
general level on both Engines A and B.