Filter
Top Products
7
SETUP EXAMPLE: PRE & POST PROCESSING
In this example, we are using the two engines
of NOVA Dynamics in two different places in a
signal chain. One engine is used in front of the
pre-amp for compression, while the other is
being used in the effects-loop as a noise gate.
• Connect your guitar to input A of the NOVA
Dynamics.
• Connect output A of the NOVA Dynamics to
the amp’s regular input.
• Connect the “Send” jack of the effect loop to
input B of the NOVA Dynamics.
• Connect output B of the NOVA Dynamics to
the “Return” jack of the effects loop.
Note: For best signal to noise ratio, calibrate the
pedal according to the level of the input signal.
You will love the fact that each engine of the
NOVA Dynamics has its own individual level
calibration. For further information, refer to this
manual’s “Calibration” section.