Filter
Top Products
12 – PRESET Button
Press the PRESET button once to enter Preset mode.
Press it several times to step through presets. In
Preset mode, you can store and recall up to nine
different presets. In bank mode up to 18 (2x9) presets
can be stored.
Please also refer to the section “Limiting the Number of
Presets” in chapter “Presets” of this manual.
13 & 16 – EFFECT Buttons
Use the EFFECT buttons to switch the two effects on
or off individually and to set the effect type for each
Engine. Press an EFFECT button once to engage that
effect’s Engine. Press and hold an EFFECT button to
disengage that Engine. Please note that it is not
possible to disengage both Engines at the same time.
If only one Engine is active and you disengage that
Engine, NOVA Modulator will automatically engage the
other Engine.
If you want to fully switch off both Engines (i.e., bypass
the pedal), use the ON/OFF switch.
Press an EFFECT button several times to select
between the different effect types. The available types
are Chorus, Tri-Chorus, Flanger (LED red), Through-
Zero-Flanger (LED green), Phaser, Tremolo and
Vibrato.
14 & 17 – VARIATION Buttons
The various effect types have so-called variations.
E.g., for the Tremolo, there are “hard” and “soft” types.
The Chorus has phase tilts. You will find additional
information on these variations in the manual section
describing the effects.
18 – SPEED LEDs
When LFO SYNC mode is not active
, you can change
the speed of the two engines individually using the
SPEED knobs and the TAP TEMPO switch.
Only one Engines SPEED LED will be lit at any time as
the TAP TEMPO switch directly controls the tempo of
the other Engine.
(See also the “LFO Sync mode “off” example on page
26).
When LFO SYNC mode is active
, the same speed is
applied to both Engines. In this case, the speed is
OVERVIEW
13