Filter
Top Products
PRESETS
29
Bank mode
Bank mode allows you to store up to nine banks
holding two presets each. This is the mode to use if
you have a number of different songs that require
dedicated presets.
Selecting Bank mode:
• Enter Calibration mode by holding the MANUAL
button for one second. The PRESET button’s LED
should now be flashing. If it is steady lit, press the
PRESET button once.
• Exit Calibration mode by pressing any button other
than PRESET.
The 7-segment display now shows the current preset
bank. For each of the nine banks, you can store two
presets. The presets are dedicated to the PRESET and
MANUAL buttons.
Preset #1 Preset #2
Alternating between the two presets in a bank can be
done in two ways:
• Press the PRESET button (for preset #1) or the
MANUAL button (for preset #2) or
• Press and hold the ON/OFF button for approx. one
second.
Selecting banks can also be done in a couple of ways
:
• You can press the PRESET button several times to
step through the banks or
• You can press the TAP/TEMPO switch once and
immediately thereafter the ON/OFF button multiple
times.
See also the example on how to select presets using
the TAP TEMPO and ON/OFF switches on pages 10-11.
Bank mode differs from Preset mode in the
following ways:
- when the MANUAL buttons LED is lit it means that
preset #2, in the current bank is recalled. Unlike in
Manual mode – you can not rely on the position of the
knobs as an indication of the current parameter values.