Filter
Top Products
11
ENGLISH
D
DIGITAL IN terminal [DIGITAL IN]
To record digital audio signals, connect this terminal to the digital
output terminal of a digital device such as a CD player with a
commercially available optical digital cable.
If the sampling frequency of the input digital signal is changed
while an optical digital cable is connected, it might not be recog-
nized correctly. (“OPTICAL UNLOCK” will appear on screen.)
If this occurs, disconnect the optical digital cable from the con-
nector once and reconnect it after changing the frequency.
Alternately, after changing the frequency, you can turn the power
off once and then turn it on again.
< When the sampling frequency of the input digital signal is 48 kHz,
some of the audio specification values might differ.
E
USB port (B-type) [USB]
Connect this to a computer USB port to convert sound from this
unit to a digital signal and output it to the computer.
F
AC Power Cord
After all other connections are complete, connect the plug to an
AC wall outlet.
Q If you do not use this unit for a long period of time, unplug
the power cord from the wall outlet.
Q Be sure to connect the power cord to an AC outlet that
supplies the correct voltage.
Q Hold the power plug when plugging it into an outlet or
unplugging it. Never pull or yank on the power cord.
Q After all connections are complete, connect the power cord’s
plug to the AC wall socket.
< Read the instructions of each device that you intend to use
with this unit.
< Be sure to connect each plug securely. To avoid hum and
noise, do not bundle the connection cords.
A
LINE IN/OUT jacks
These jacks transmit an analog 2-channel audio signal. Connect
the components using the included RCA pin cables.
Be sure to connect:
White plug e White jack (L: left channel)
Red plug e Red jack (R: right channel)
White (L)
Red (R)
White (L)
Red (R)
B
PHONO jacks [PHONO]
Connect the turntable’s RCA pin cable to the PHONO jacks.
Be sure to connect:
White plug e White jack (L: left channel)
Red plug e Red jack (R: right channel)
< Moving Magnet (MM) cartridges can be used for this unit.
C
SIGNAL GND [SIGNAL GND]
Connect the ground lead of the turntable to this terminal.
< This is not a safety earth.
< If the turntable’s ground lead is not connected to this terminal,
hum noise may be heard.
AD-RW900 (back side)
Wall
socket
PLAY
(IN)
REC
(OUT)
TAPE/MD/CD-R
Turntable
CD Player,
MD Deck, etc.
DIGITAL OUT
Computer
A
B
D
E
F
C
RCA cables
RCA cables
Amplier
USB cable
Optical digital cable