Filter
Top Products
E 13
ENGLISH
Operation
• Press the STANDBY/ON button of the unit once to turn on power of the system.
Adjusting the volume
You can adjust the volume on the unit.
Press VOLUME +/- until the desired volume is reached, and volume level is displayed on the
display.
Setting the Clock
The LCD display for the clock time.
1. Press CLOCK ADJ. button and the time digits begin to flash on the display.
2. Press HOUR button to set the hour. Press and hold for more than 1 sec to enter fast setting.
3. Press MINUTE button to set the minutes. Press and hold for more than 1 sec to enter fast
setting.
4. Press CLOCK ADJ. button to confirm. The time digits stop flashing and the clock is set
and starting to run.
5. Press and hold the DST button on the remote to change the daylight saving time. DST on will
advance the time 1 hour. DST off will turn the clock back 1 hour.
Using the Alarm
Setting Alarm Time
1. The unit can set two Alarm Time.
2. Press and hold the ALARM 1 Button or ALARM 2 button until the display flashes. Press the
HOUR or MINUTE button until the desired alarm time is displayed. Remember to set the correct
AM or PM (an icon to the right of the time display is the PM indicator. There is no AM
indicator).
3. Press the WAKE TO button to select the radio, iPod, CDG or buzzer to wake to a
corresponding Wake icon will light up for the selected Wake sound.
4. Press the ALARM 1 button or ALARM 2 button (or ENTER button) again to exit the setting
mode. The alarm time and wake to mode are set.
5. Press ALARM ON/OFF to select activating ALARM 1, ALARM 2 or ALARM 1+ ALARM 2.
6. When ALARM armed, you can press ALARM ON/OFF to stop ALARM.
Note:
• Once you set the alarm time, the alarm will be automatically armed. The Alarm icon and Wake
icon will appear to indicate the alarm is armed. Will be automatically armed for 60 minutes.
• Make sure to adjust volume level for comfortable wake up volume.
• When the Alarm wake to “iPod” mode, if “iPod” not docked, alarm will activate Buzzer instead.
• When the Alarm wake to “CD” mode, if there is no Disc loaded, alarm will activate Buzzer
instead.
Resetting the Alarm for the Next Day
When the alarm is sounding, press the STANDBY/ON button to stop alarm and reset it for the
following day.
CLOCK/ALARM OPERATIONS