Filter
Top Products
4. Connect an instrument cable from the LEFT/MONO jack to a
line-level input on your amp or mixer. Turn the volume control on
your amp down but not off.
5. Connect an instrument cable from your signal source to the
AUDIO IN jack. You can feed virtually any instrument-level
or line-level signal through your MF-105B. Examples are bass,
keyboard, theremin, drum machine, or effects send output on your
mixer. Play your instrument (or turn on the signal source). Adjust
the volume control on your monitor amp so that the sound level is
comfortable.
Figure 2 - Basic Settings
6. Now set the MF-105B panel
controls as follows (See Figure
2):
PATTERN 2
ENVELOPE 2
RATE 6
MIX 10
BANK A/B A
Filter Sliders 1-8 All the
way up.
Press the stomp switch. The BYPASS light will now turn green.
Playing your instrument, set the DRIVE control so that the DRIVE
indicator lights up yellow most of the time. You will also hear the
ltered signal. Adjust the OUTPUT control so the Bass MuRF’s
effected signal is about the same loudness as the bypassed signal.
7) Continue to play your instrument, holding sustained notes or
extended sounds. Your instrument’s signal is going through the
Bass MuRF’s lters. Listen to how it affects the quality of your