Filter
Top Products
REAR PANEL HOOK-UP
(CONTINUED)
Insert: To use the “INSERT” effectively you will need an insert cable. The insert cable or “Y” adaptor, as it is sometimes referred to as,
typically has a stereo 1/4” “phone” jack on one end and two mono RCA jacks or 1/4” jacks on the other. Most apadtors of this type are
available at electronics stores, such as Radio Shack. Connect the stereo 1/4” phone jack to the “INSERT” jack on the KJM-7900 then
connect the two “mono” ends to the signal jacks on you external effects unit (see your owners manual). Once your external effects unit is
properly connected to the KJM-7900, you will be able to adjust the incoming signal from your external effects unit (as described your users
manual). In some cases you may receive high frequency “noise” from an external effects unit. In this case, you can adjust some of the
“noise” out by using the high frequency channel “EQ” fader.
Mic Sections 1, 2 and 3
Line: The “LINE” connector jacks can be used to connect a high impedence microphone or an instrument.
Aux 2 L and R: The “AUX 2 SEND” left and right connectors send a stereo signal from the selected channel to an external processing
device. The level at this output is controlled by the AUX The “AUX 1 RETURN” input connectors (stereo) returns the signal from an
external special device and is controlled by the AUX 2 Send fader on the board.
“Source Section’s 1 and 2” (PHONO/LINE)
Source sections 1 and 2 are designed to connect turntables or additional players. If you are connecting a turntable be sure to connect it to
the “PHONO L and R” jacks.These jacks have a lower signal output and are designed speciffically to connect turntables. Be sure to set the
toggle switch on the board to “phono” otherwise there will be no sound output. Additional players can be connected to the “LINE” input
jacks, however the line inputs have no video switching capability. If you are using a player with video output, and wish to use the video
input you must use the corresponding CD, LD, or DVD input jacks, as they correspond to the video input section.
Aux 1 Send: The “AUX 1 SEND” sends a mono signal from the selected channel to an external mono processing device. Connect the
AUX 1 send to the input of an extrernal effects device. The level for the AUX 1 send is controlled by AUX 1 send fader on each channel.
Auxiliary Send and Return
Aux 1 Return: The “AUX 1 RETURN” input connectors (stereo) returns the signal fron an external special device and is controlled by
the “STEREO RETURN (AUX 1)” located on the board.
“XLR” Connector: Use the “XLR” connector for your low impedence microphone and cable.
Note: The “LINE” and “XLR” inputs will not work at the same time. A microphone connected to the “XLR”
input will cancel out anything connected to the line input.
3
VIDEO OUT
VIDEO IN
AUDIO IN
VIDEO IN
AUDIO IN
STEREO RETURN
MONITOR OUT
RECORD OUT