Filter
Top Products
PARTS AND FUNCTIONS
(MUSIC MODULE)
5
2
4
6
7
8
9
10
3
11
5
12
13
14
1
2.
Source Selector: Channel 3 allows the user to connect up to three players
with video output. The source selector switch makes it possible to switch
easily between players by “toggleing” it to the desired position.
3.
Gain: This controls the input level for players connected to the
corresponding channel. It can be adjusted from 20dB to 60 dB.
1.
Source Selector: Channels 1 and 2 allow the user to connect two players
without video output. The source selector switch makes it possible to switch
easily between players by “toggleing” it to the desired position.
8.
11.
Channel Fader: The fader raises or lowers the music volume of that
particular channel.
Balance: This control “balances” the music signal between the left and right
channels.
Crossfader Assign Toggles: These toggles work in conjunction with the
crossfader slide control. They allow the user to select the channels to be
included in the “cross fade”.
Master 1 / Master 2 & Key Control Switch: This switches the music
between the Master 1 channel and the Master 2/Key Control channel.
Important: In order to use the key control feature the switch must
be in the down position.
12.
13.
Cross Fader Slide Control: The slide control allows the user to fade the
music out from one source and fade in to another source to creating a
“blending” effect of the music.
14.
High EQ: This controls the level for a preset high frequency range. Use this
control to boost ro reduce the high end frequencies in the music signal.
4.
5.
6.
Mid EQ: This controls the level for a preset mid frequency range. Use this
control to boost ro reduce the mid frequencies in the music signal.
Low EQ: This controls the level for a preset low frequency range. Use this
control to boost or reduce the low frequencies in the music signal.
7.
Aux 1: This control works in conjunction with the “master” Aux1 Send on
the Master module panel. It controls the level of “effect” (whatever external
device is connect to the Aux 1) for that individual channel. It is Pre EQ.
10.
Cue: This button monitiors the input signal from the board to the headphones.
Press this button to hear only that channel through the headphones. Note: if
you have pressed more than one channel cue, those channels will be audible as
well.
9.
Aux 2 On /Off Switch: This control works in conjunction with the “Master”
Aux 2” Send and the built in digital echo effect on the Master module panel.
In the up position Aux 2 is bypassed.