Filter
Top Products
13
Public Address/Presentation
For this set up, there are four microphones connected to
channels 1-4. These microphones can be either the optional
UHF wireless channels, low-impedance corded microphones,
or high-impedance corded microphones. Source music
devices are connected to channels 5-8. Note that when
connecting stereo source music devices to either CH. 5/6
or CH. 7/8, you can either connect via 1/8” mini-jack,
RCA or L/R ¼”. If connecting mono source audio devices,
connect them the CH. 5-8 via the ¼” jacks. Note that CH.
5/6 and 7/8 will be controlled together by the channel
strips. If connecting a single mono signal to either CH. 5/6
or CH. 7/8, connect to the L(MONO) jack.
For power output, this example shows PA-PRO 900
confi gured for MAIN L/R+MONITOR output. A pair of
passive speakers is powered by the MAIN L./R speaker
connector. A passive monitor speaker is powered by the
MONITOR speaker connector. An additional set of powered
speakers can be connected to the MAIN OUT jacks on the
front panel.
Recording can be done either with an optional SDR-3 SD
recorder, or to an external recording device connected to
the RCA record out jacks on the front panel.
NOTES:
If connecting a single mono signal to either CH. 5/6 or CH.
7/8, connect to the L(MONO) jack.
The optional UHF wireless mic channels require the SOURCE
SELECT switch to be set to UHF.
POWER AMP ASSIGN switch must be best to MAIN L/
R+MONITOR
Hookup Diagrams