Filter
Top Products
9
House of Worship/Full Band
For this example, there are four microphones connected to
channels 1-4. These microphones can either be the optional
UHF wireless channels, low-impedance corded microphones,
or high-impedance corded microphones. Musical
instruments are connected to channels 5-8. Note that when
connecting instruments to channels 5-8, the LEVEL control
will need to be set rather high due to the lower signal level
from instrument output. It is preferable to use channels 1-4
for instruments if you are using less than four microphones.
If there is a need to connect a laptop or other stereo music
source, you can connect to the designated stereo inputs on
channels 5/6-7/8.
For power output in this example, the PA-PRO 900 is
confi gured for MAIN L/R+MONITOR output. A pair of
passive speakers is powered via the MAIN L./R speaker
connector. A passive monitor speaker is powered via the
MONITOR speaker connector. An additional set of powered
speakers can be connected to the MAIN OUT jacks on the
front panel.
Recording can be done either with an optional SDR-3 SD
recorder (optional accessory), or to an external recording
device connected to the RCA record out jacks on the front
panel.
NOTES:
UHF wireless mic channels require the SOURCE SELECT
switch to be set to UHF.
POWER AMP ASSIGN switch must be best to MAIN L/
R+MONITOR
Hookup Diagrams