Filter
Top Products
18
18. ECHO DELAY
– This control is used to adjust the
18. ECHO DELAY – This control is used to adjust the 18. ECHO DELAY
length of time between each echo repetition. When set to
minimum, the echo repetitions will occur rapidly, with little to
no time between them. As this control is turned clockwise,
the time between each repetition will increase.
19. DSP ON/OFF
– Use this control to quickly enable or
disable all DSP effects. This can be used to switch to a
“dry” signal for DJ or speaker announcements. When the
announcements are over, hit the button again to reapply
the effects. When the button is in the OUT position, all DSP
effects are off; when the button is in the IN position, all DSP
effects are on.
20. REVERB LEVEL
- This control adjusts the overall level
of the reverb effect. Use this control to adjust the amount
of REVERB applied when adjusting the master effect level
control. To increase reverb, turn the control clockwise. To
decrease reverb, turn the control counter-clockwise.
21. HISS FILTER
– Thue control is used to reduce the
amount of sibilance in the vocals while using DSP echo with
repeat. As the control is turned clockwise, less sibilance will
occur during each echo repitition.
NOTE: This feature only works when DSP repeat is applied.
22. MASTER EFFECT LEVEL
– This control is used to
adjust the overall level of all the effects combined. Use this
control after you have already made individual adjustments
to the reverb, echo and hiss fi lter controls. If you fi nd that
you applied too much or too little DSP effects and need to
quickly make an adjustment to all the channels, use this
control.
Note: There are two other locations to adjust the amount
of DSP that goes into the mix: The DSP controls on the EQ
panel, and the DSP controls on the channel strips.
23. FOOT SW.
– This input jack is for connecting an
external footswitch that can be used to enable or disable
DSP effects. The DSP ON/OFF button needs to be in the ON
position to use the footswitch. Any single-button footswitch
with a ¼” TRS plug can be connected and used.
24. ST CH EFFECT LOOPS
These ¼” insert jacks are for connecting external effects
devices such as digital key controllers, equalizers, and sonic
enhancers. With an insert jack, a signal can leave the jack
to an external processor, and return post-processed via the
same insert jack. A special insert cable is required, see
your effects processor manual to determine what type of
cable to use. Effect integration via the effect loop jacks is
only available to signals from CH-5-8. If a stereo device is
connected to CH. 5/6 or 7/8, you need to make an insert
connection for each channel (L/R). Note that the loop jacks
are sent before the signal hits the on-board EQs, so keep
that in mind if you are using the insert jacks to integrate an
external EQ.
Front Panel Features