Filter
Top Products
9
1
2
3
4
a
6
9
10
11
12
13
14
8
7
d
c
b
5
1
2
3 4 5 6 7 8
9
Rear Panel
Rear Panel Descriptions
1. BALANCED OUTPUT - Connect your Left and Right XLR cables from the VSP-M1 to balanced inputs on your
mixer, amplifier or powered mixer.
2. TRIM OUTPUT - The output level from the VSP-M1 can be adjusted using this control. For the best, clean sound
quality, adjust TRIM until just before the signal begins to distort.
3. AUDIO OUT - Connect your Left and Right RCA cables from these VSP-M1 outputs to a stereo, Home
entertainment system, amplifier, mixer or powered amplifier with RCA in jacks.
4. AUDIO IN - You can connect up to 3 music sources for input selection here, including stereos, disc players,
mixers, etc.
5. MIC INSERT - This jack is used for connection of an outboard processor such as a compressor using only a
single 1/4” TRS (Tip = send, ring = return, Sleeve = signal ground).
6. ECHO ON/OFF - MIC 3 is the only MIC input which allows you the ability to bypass the ECHO effect entirely
rather than simply turning the ECHO level all the way to zero. Press this button in to turn the effect OFF. In the
extended postion, the effect is ON.
7. MIC 1, 2 and 3 INPUTS - These jacks accept either 1/4” microphone cables in the center of the input, or line up
the 3 prongs of an XLR cable with the XLR connection around the center.
8. FOOTSWITCH - Connect any standard footswitch via 1/4” cable here for remote control of the VSP-M1.
9. AC 10V ADAPTOR JACK - Connect included power adaptor here.