Filter
Top Products
5
Quick start
This Quick Start section is for those of you who would like to start using your
new amp right away.
This manual contains information that will help you take full advantage of
your Valvetronix amp, so be sure to read the rest of it after you’ve read the
Quick Start section.
HINT: Illustrations of the top panel and rear panel are provided in “Top
and rear panels” (p. 7), so refer to them as you try out your amp.
Setup
1. Turn the MASTER volume (p. 8) control on the amp all the way down.
2. Connect the included power cable to the AC power connector on the rear
panel, and plug the other end into an AC outlet.
3. Plug the cable connected to your guitar into the top panel INPUT jack.
4. Turn on the POWER switch.
5. Slowly raise the MASTER volume to adjust the volume.
HINT: The POWER LEVEL control adjusts the output level of the power
amp.
NOTE: There may be no sound for several seconds until the vacuum tube
warms up. This is not a malfunction.
Checking out the preset programs
1. Press the top Panel PRESET switch.
The PRESET LED will light up (Preset mode).
2. Turn the AMP selector to choose an amp model.
A preset program for a sound that is typical of each amp model will be re-
called, and the GAIN, VOLUME, TREBLE, MIDDLE, BASS, and effect settings
will switch automatically.