Filter
Top Products
194 Chapter 17—Remote Control
01V96 Version 2—Owner’s Manual
• If no check boxes are selected:...........Pro Tools timecode format is set to “Min-
utes:Seconds” or “Samples.”
C SELECT ASSIGN
This parameter indicates the current parameter, which can be adjusted via the parame-
ter controls on the page. For example, Pan, PanR, SndA, SndB, SndC, SndD, or SndE
(see page 196).
D P.WHEEL MODE
This parameter indicates the function currently assigned to the Parameter wheel (see
page 197).
E INSERT ASSIGN/EDIT section
This section enables you to insert plug-ins into Pro Tools channels and adjust plug-in
settings. Use the left and right [ ]/[ ] Tab Scroll buttons to change the parameters
displayed in this section.
• ASSIGN .........................Turn on this button to insert plug-ins into Pro Tools channels.
(If you are using the TDM system, you can also assign outboard
effects processors.)
• COMPARE.................... You can compare your edits with the original settings by turn-
ing on this button. This button works in unison with the Com-
pare button in the Pro Tools Inserts and Sends windows.
• BYPASS .........................Turning on this button bypasses the plug-ins (see page 204).
• INSERT/PARAM.......... Switching this button to INSERT enables you to assign plug-ins
using four rotary controls on the page. Switching this button to
PARAM enables you to adjust the plug-in parameters using the
four rotary controls (see page 203).
• Information box.......... This box displays plug-in parameter names, values, alarm mes-
sages from Pro Tools, etc.
• Rotary controls 1–4..... These controls enable you to select plug-ins or adjust the
selected plug-in parameters.