Filter
Top Products
206 Chapter 17—Remote Control
01V96 Version 2—Owner’s Manual
Nuendo/Cubase SX Remote Layer
You can remotely control Nuendo and Cubase SX using the Remote Layer.
■ Configuring Computers
1 Connect the 01V96 to your computer using a USB cable, and install the
required USB driver included on the 01V96 CD-ROM.
Refer to the Studio Manager installation guide for more information on installing the
driver.
2 Launch Nuendo/Cubase SX, select the Device Setup menu, and set up
Nuendo/Cubase SX so that the 01V96 can communicate with the software.
Refer to the Nuendo/Cubase SX User’s Manual for more information on setting up the soft-
ware.
■ Configuring the 01V96
1 Refer to page 192 to configure the DIO/Setup | MIDI/HOST page.
2 Press the LAYER [REMOTE] button to set the TARGET parameter to
Nuendo/Cubase SX.
You can now remotely control Nuendo/Cubase SX using the Remote Layer.
Other DAW Remote Layer
You can remotely control DAW software that supports the Pro Tools protocol.
■ Configuring Computers
1 Connect the 01V96 to your computer using a USB cable, and install the
required USB driver included on the 01V96 CD-ROM.
Refer to the Studio Manager installation guide for more information on installing the
driver.
2 Launch and set up the DAW software so that the 01V96 communicates with
the software.
Refer to the DAW software’s user’s manual for more information on setting up the software.
■ Configuring the 01V96
1 Refer to page 192 to configure the DIO/Setup | MIDI/HOST page.
2 Press the LAYER [REMOTE] button to set the TARGET parameter to General
DAW.
You can now remotely control the DAW software using the Remote Layer.