Filter
Top Products
Pro Tools Remote Layer 205
01V96 Version 2—Owner’s Manual
Remote Control
17
5 Rotate the Parameter wheel.
Rotate the Parameter wheel clockwise to scrub or shuttle forwards. Turn it counterclock-
wise to scrub or shuttle backwards.
The minimum scrub playback step varies depending on the zoom setting in the Pro Tools
Edit window.
6To cancel the Scrub or Shuttle function, press the User Defined button or
DAW SHUTTLE to which you assigned the DAW SCRUB parameter in Step 1.
Alternatively, you can cancel the Scrub or Shuttle function by pressing the User Defined
button to which the DAW STOP parameter is assigned. The Scrub function is automatically
cancelled if you commence playback or fast forward.
Automation
If you assign a parameter that controls Pro Tools Automation mode (such as DAW Auto
Read, DAW Auto Touch, etc.) to one of the User Defined buttons, you can control the Auto-
mation settings for each channel by using that User Defined button. See page 235 for more
information on assigning parameters to User Defined buttons.
Press the STEREO OUT channel [SEL] button. The button indicator lights up, and the
Channel 1–16 [SEL] buttons become available for the Automation mode setting.
Press the desired channel [SEL] buttons while pressing the programmed User Defined but-
ton to switch the corresponding channels’ Automation settings.
While the channel [SEL] buttons are available for the Automation mode setting, pressing
the [SEL] buttons will cause the Fader Touch or Untouch command to be transmitted to
Pro Tools. This is useful for Automation punch in and out recording.
Depending on the currently-selected Automation mode, the channel [SEL] button indica-
tors operate as follows:
Note: The Scrub/Shuttle operation might be stopped unexpectedly by Pro Tools. Therefore,
whenever you use the Scrub or Shuttle function, make sure that the P.WHEEL MODE param-
eter indicates “SCRUB” or “SHUTTLE.” You can check the Scrub/Shuttle function status by
viewing the corresponding User Defined button indicator.
Note: Operating a fader also causes the Fader Touch command to be transmitted. Also, when-
ever the transport mode changes (such as Play and Stop), the Fader Untouch command is
transmitted.
User Defined Keys
Function
Pro Tools Automation
Mode
[SEL] Button Indicators
DAW AUTO WRITE
Auto write
Flashing red (Record Ready)
Red (Recording)
DAW AUTO TOUTCH
Auto touch
DAW AUTO LATCH
Auto latch
DAW AUTO READ
Auto read Illuminated steadily
DAW AUTO OFF
Auto off Off