Filter
Top Products
52 Chapter 5—Tutorial
01V96 Version 2—Owner’s Manual
• Using Direct Outs
Each Input Channel signal is directly routed to and output from the specified output con-
nectors and channels. Use this method to patch each Input Channel directly to each MTR
track.
The following example illustrates the signals directly output from ADAT OUT channels
1–5.
This section describes how to route signals by combining the above two routing methods.
1 Press the DISPLAY ACCESS [PAN/ROUTING] button repeatedly to display the
Pan/Route | Rout1-16 page.
This page enables you to select a Bus Out as the signal destination for each channel.
This page contains the following buttons:
A 1–8 buttons
These buttons route Input Channel signals to Buses 1–8. You can select multiple but-
tons.
B S button
This button routes Input Channel signals to the Stereo Bus.
C D button
This button routes Input Channel signals to the specified output connectors and chan-
nels directly.
CH 1
CH 2
CH 3
CH 4
CH 5
Input
Patch
INPUT connector 1
INPUT connector 2
INPUT connector 3
INPUT connector 4
INPUT connector 5
ADAT OUT
connector
Input Channels 1
Input Channels 2
Input Channels 3
Input Channels 4
Input Channels 5
3
1
2