Filter
Top Products
4. After the song has finished, press the [STOP] key to end the recording of
the Stereo Track.
Tip: In order to have a loud CD, the Stereo Meter (L R Meters) of the AW16G should be
as close as possible to 0 dB without going over. If the levels are significantly below the 0
dB mark you should readjust the levels closer to the 0 dB mark.
The Mastering Library may also be useful when recording the Stereo Track. For more
info on using the mastering Library see page 73 of the manual.
Creating an Audio CD
After the Stereo Track is recorded you can create an audio CD of the
song.
1. Insert a blank CD-R in the CD-RW drive of the AW16G.
In order to create an audio CD, a CD-R should be used. Most consumer CD
players will not read audio recorded on CD-RW media. It is best to use CD-R media
designed for digital audio.
2. Press the [CD] key in the Work Navigate
section until the CD WRITE screen is
displayed.
3. Select either TRACK AT ONCE or DISC AT ONCE and press the
[ENTER] key. An INIT CD LIST progress message will pop up.
Track At Once writes the audio to the CD and places an interval of two seconds
between each track. It does not automatically finalize the CD. You will need to finalize
the disc in order to play it in a consumer CD player.
Disc At Once writes the audio to the CD and does not place any space between
the tracks. It will automatically finalize the CD, allowing it to be playable on a consumer
CD player.
20