Filter
Top Products
48
CLP-880/860/840/820/820S
1
• Be careful not to confuse parts, and be sure to install all parts in the
correct direction. Please assemble in accordance with the sequence
given below.
• Assembly should be carried out by at least two persons.
• Be sure to use the correct screw size, as indicated above. Use of
incorrect screws can cause damage.
• Be sure to tighten up all screws upon completing assembly of each
unit.
• To disassemble, reverse the assembly sequence given below.
Have a Phillips-head (+) screwdriver ready.
Z
Open the box and remove all the parts.
On opening the box you should find the parts shown in the
illustration. Check to make sure that all the required parts are
provided.
CLP-880: Keyboard Stand Assembly
5 x 40 mm long gold screws
6 x 20 mm round-head screws
4 x 12 mm round-head screws
4 x 20 mm tapping screws
6 x 16 mm flat-head screws
Bundled pedal cord inside
F
D
A
B
C
E
x 6 1
x 4 2
x 8 3
x 4 4
x 4 5
● Cord holders x 2 ● AC power cord
B
C
◆ B and C are already attached on the CLP-880PE. The 5 x 40 mm long gold screws are not supplied with the CLP-880PE.