Filter
Top Products
53
CLP-880/860/840/820/820S
8 9
Cord holder
● A voltage selector is provided in some areas.
240
127
110
220
<
Connect the pedal cord.
The pedal cord from the pedal box must be plugged into the
PEDAL connector on the rear of the main unit. Once connected,
attach the cord holders to the rear panel as shown, then clip the
cord into the holders.
>
Voltage Selector
Before connecting the AC power cord, check the setting of the
voltage selector which is provided in some areas. To set the
selector for 110V, 127V, 220V or 240V main voltages, use a
“minus” screwdriver to rotate the selector dial so that the correct
voltage for your region appears next to the pointer on the panel.
The voltage selector is set at 240V when the unit is initially
shipped.
After the proper voltage has been selected connect the AC
power cord. A plug adaptor may be also provided in some areas
to match the pin configuration of the AC wall outlets in your
area.