Filter
Top Products
Internal Design of the CP5 & CP50
Reference
Left & Right Parts
[VOICE]
[PRE-AMP]
[MOD-FX]
[PWR-AMP] (CP5 only)
[LEFT1]/[LEFT2]/[RIGHT1]/
[RIGHT2] (CP5)
[LEFT]/[RIGHT] (CP50)
[COMMON]
Song Setting Area
[SONG SETTING]
[RECORD]
TRACK Part
[TRACK]
MIC INPUT Part
[MIC INPUT] (CP5 only)
Settings for All Parts
[REVERB]
Settings for All Performances
[MASTER COMPRESSOR]
[UTILITY]
[FILE]
Appendix
26 CP5/CP50 Reference Manual
For non-piano voices:
In the case of non-piano voices, effects are selected from the categories that make up the Other
group as described above. In addition, the power amplifiers and the compressor designed for
PIANO and E.PIANO voices are grouped together in the PWR category. See For PIANO and
E.PIANO voices (page 25) for more details on these. All effects for non-piano voices function as
insertion effects.
Configuring Power-Amplifier / Compressor Block Parameters
Each power-amplifier / compressor type is configured using a different set of parameters, which
adjust the sound produced by the block in various ways. All parameters for the power amplifiers
and the compressor specially designed for PIANO and E.PIANO voices are described in alphabetic
order in the following table. The effects from the Other group are identical to those from the Modula-
tion Effect block, and details on their parameters can be obtained from the table on page 19.
NOTE For more details on the specific parameters associated with each different type of effect, see the Power-Amplifier /
Compressor parameter list in the Data List pdf document.
Power-Amplifier & Compressor Parameters
Edit Sequence
Press and hold the [PWR-AMP] button (for at least one second) Navigate to the
second and subsequent pages using the [ PAGE] and [PAGE ] buttons Turn Knobs
1 to 3
On-screen name
(and full name)
Associated effects Description
A Attack Compressor 376 This parameter is used to set the amount of time
that elapses between arrival of an input signal and
activation of the compressor.
D Drive Compressor 376 This parameter is used to adjust the degree to
which compression is applied.
L LineBal
(Line Balance)
PowerAmp 71Rd I/73Rd I/
75Rd I/78Rd II/69Wr/77Wr
This parameter is used to adjust the balance
between the speaker output (S) and line output (L).
O Output PowerAmp 71Rd I/73Rd I/
75Rd I/78Rd II/69Wr/77Wr,
Compressor 376, and Clean
Amp
This parameter is used to set the output level.
R Ratio Compressor 376 This parameter is used to set the compression
ratio.
Release Compressor 376 This parameter is used to set the amount of time
over which the compressor stops compressing the
sound.
Effect category
Effect name