Filter
Top Products
Appendix
CVP-405/403/401 Owner’s Manual
206
CVP-405: Keyboard Stand Assembly
CAUTION
• Be careful not to confuse parts, and be sure to install all
parts in the correct direction. Please assemble in accor-
dance with the sequence given below.
• Assembly should be carried out by at least two persons.
• Be sure to use the correct screw size, as indicated below.
Use of incorrect screws can cause damage.
• Be sure to tighten up
all screws upon com-
pleting assembly of
each unit.
•To disassemble,
reverse the assembly
sequence given below.
1 Remove all parts from the box. Confirm that all
parts shown in the illustration are provided.
2 With the key cover closed and the keyboard side
on the bottom, lean A against the wall.
Spread a large soft cloth, such as a blanket, on the floor.
Place the unit A on the cloth with the keyboard side on
the bottom and lean A against the wall so that it will not
fall or slip. Place a soft cloth against the wall to protect
the instrument and wall from scratches.
CAUTION
• Be careful not to pinch your fingers.
• The top part of the music rest is not fixed. When you lean
the unit against the wall, support the music rest with your
hand so that the music rest will not fall.
CAUTION
• Do not place the unit A with
the rear side facing down.
• Do not lay the unit A upside-
down on the floor.
3 Attach B and C.
4 Attach D.
5 Raising A to the standing position.
Use the B and C as support to raise A.
CAUTION
• Be careful not to pinch your fingers.
• When you raise A, do not hold the key cover.
Have a Phillips-head (+) screw-
driver ready.
A
DC
B
E
AC power cord
5 ✕18 mm fixing
screws ✕ 14
Bundled pedal
cord inside
CAUTION
To prevent the
key cover from
accidentally
opening during
assembly, press
down on the
key cover, mak-
ing sure that
the sheet
(shown) remain
in place.
A
Be sure to position the keyboard side on the bottom.
CAUTION
Please do not touch the speaker
net. Doing so may damage the
speaker inside.
Incorrect
Incorrect
BC
A
B
A
B
1 Fix B to the bottom
surface of A using
two screws.
2 Fix B to the speaker
box using two screws.
3 Fix C in the same way.
If the screw holes do not align, loosen the other screws and
adjust the position of C and D.
If the screw holes do not align, loosen the other screws and
adjust the position of D.
D
A
1 Fix D to the bottom
surface of A using
two screws.
2 Fix D to the speaker box
using two screws.
A