Filter
Top Products
12 Front and rear panel
EMX5000-20/EMX5000-12—Owner’s Manual
G PFL (pre-fader listen) switch
When this switch is turned on, the signal at the
point before the ST control knob F is sent to the
PHONES jack (input/output panel D).
■ Master control section
In this section, you can adjust the final level of
the outputs.
H AUX 1 fader
The AUX 1 fader adjusts the final level of the sig-
nal sent from the AUX 1 bus to the AUX SEND 1
jack (input/output panel 8). If the Power amp
select switch Y is set to AUX 1-MONO, using
this fader enables you to adjust the level of the
signal sent from the SPEAKERS A 1/2 jacks to the
speakers.
I AUX 2 fader
The AUX 2 fader adjusts the final level of the sig-
nal output from the AUX 2 bus to the AUX
SEND 2 jack (input/output panel 8). If the
Power amp select switch Y is set to AUX 1-
AUX 2, using this fader enables you to adjust the
level of the signal sent from the SPEAKERS B 1/2
jacks to the speakers.
J MONO OUT fader
The MONO OUT fader adjusts the final level of
the monaural signal output from the STEREO
bus to the MONO OUT jack (input/output panel
C).
If the Power amp select switch Y is set to AUX 1-
MONO, this fader also adjusts the level of the sig-
nal sent from the SPEAKERS B 1/2 jacks to the
speakers.
If the Power amp select switch Y is set to MONO
BRIDGE, this fader adjusts the level of the signal
sent from the SPEAKERS A 1 jacks to the speaker.
K ST OUT fader
The ST OUT fader adjusts the final level of the
signal sent from the STEREO bus to the ST OUT
jacks (input/output panel 0). If the Power amp
select switch Y is set to ST L-R, this fader also
adjusts the level of the signal sent to the SPEAK-
ERS jacks (rear panel 3).
L AFL (after fader listen) switch
When this switch is on, the output signal that
passes through the corresponding fader is sent to
the PHONES jack (input/output panel D). Use
these switches when you wish to monitor a par-
ticular output signal through the headphones.
■ 2TR IN section
In this section, you can adjust the input level of a
cassette deck or a CD player that is connected to
the 2TR IN jacks (input/output panel 5).
M ST (stereo) control
This knob adjusts the level of the signal sent from
the 2TR IN jacks to the STEREO bus.
N PFL (pre-fader listen) switch
When this switch is on, the signal input from the
2TR IN jacks is routed at the point before the ST
control M to the PHONES jack (input/output
panel D).
Note: The ST control setting does not affect
the level of the signal sent to the PFL/AFL buses
(pre-fader send).
H I J K
L
Note: The setting of this fader does not affect
the signal output from the STEREO bus to the
ST SUB OUT jacks.
N
M