Filter
Top Products
English
12
Turning the Power to the i88X and
Connected Devices On and Off
Before you connect the power adapter, make
sure that the i88X [STANDBY/ON] switch is set
to STANDBY (Off).
A Connect the plug of the power adapter
(PA-5D) to the DC IN terminal on the
rear panel of the i88X.
B Plug in the AC cable to an appropriate
AC outlet.
Follow this procedure in reverse order
to disconnect the power adapter.
• Be sure to use the included adapter. Using an
AC adapter other than the PA-5D may cause
damage to the i88X, and may even pose a
serious electrical shock hazard.
• Connect the adapter to an AC outlet of the
specified voltage.
Even when the [STANDBY/ON] switch is in the
STANDBY position, a small amount of electric-
ity is still flowing to the unit. When you do not
plan to use the i88X for an extended period of
time, be sure to unplug the AC power adapter
from the AC outlet.
After you connect the i88X and external
devices (page 13), make sure that the volume
setting on the i88X and external audio equip-
ment is lowered to minimum, then turn on the
power to the devices in the following
sequence.
Install mLAN Driver (for Windows)
while the power to the i88X remains off.
(See the separate Installation Guide.)
After you turn on the power to the i88X
again, restart the DAW.
To turn off the power to the devices,
first lower the volume of the audio
equipment, then turn off the power in
the reverse sequence.
To protect your speakers, before you turn the
power to the i88X on or off, lower the volume
setting on the i88X and connected audio
equipment.
A Press the i88X [STANDBY/
ON] switch to turn on the
power to the unit.
B Raise the volume of the amplifier to an
appropriate level.
C Set the i88X [GAIN] con-
trols, [MONITOR VOLUME]
control, and [MASTER VOL-
UME] control to an appro-
priate level.
Preparation
Sequence of turning on and off the
power to the connected devices
DC IN
OUT
MIDI
IN
DC IN
terminal
Rear panel
Power adapter
PA-5D
AC outlet
2
1
NOTE
WARNING
CAUTION
NOTE
Turning on the power to the i88X
POWER
ON!!
1. Turn on the power to the external
devices, such as a sound source or effects
processor connected to the input and
output of the i88X.
2Turn on the
power to
the i88X.
3Turn on the power to
the external audio
equipment connected
to the output of the
i88X. (mixer → ampli-
fier)
NOTE
CAUTION